Cordless Hammer Driver Drill MAKITA HP332DWYE 12V. (BL MOTOR)

     Cordless Hammer Driver Drill MAKITA HP332DWYE size 10 mm.(3/8")

             (Brushless motor)

            The tool is intended for impact drilling in brick, concrete and stone. It is also suitable for screw driving and drill- ing without impact in wood, metal, ceramic and plastic. 

       Standard Equipment MAKITA HP332DWYE 

             - Carry case

            - Cordless Hammer Driver Drill MAKITA HP332DWYE 

            - 2 x battery 1.5 Ah. 12V. max

            - Charger MAKITA  DC10WD 

           - Manual and Warranty

           - Screwdriver bit

        Adjusting the fastening torque MAKITA  HP332DWYE 

             The fastening torque can be adjusted in 20 steps by turning the adjusting ring. Align the graduations with the arrow on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 20.
            Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. The following shows the rough guide of the relationship between the screw size and graduation. 

         Speed change MAKITA  HP332DWYE 

                  To change the speed, switch off the tool rst. Select the “2” side for high speed or “1” for low speed but high torque. Be sure that the speed change lever is set to the correct position before operation. If the tool speed is coming down extremely during the operation with “2”, slide the lever to the “1” and restart 

 Position of speed change lever  1  Speed  : Low        Torque  : High        Applicable operation :   Heavy load- ing operation 

 Position of speed change lever  2  Speed  : High       Torque  : Low         Applicable operation :    Light loading operation