Angle Grinder MAKITA GA4030 size 4 inch (720w.)

      Angle Grinder MAKITA GA4030 size 4 inch

- Powerful 6.0 AMP motor delivers 11,000 RPM for the most demanding applications.
- Compact design weighs only 3.7 lbs to reduce operator fatigue.
- Labyrinth construction seals and protects motor and bearings from dust and debris for longer tool life.
- Slide switch design with lock-on for added convenience for users.
- Zigzag varnish to seal and protect motors and bearings from dust and debris.
- All bearing design and metal gear housing for increased durability.
- Machined bevel gears last up to 2 times longer than previous models.
- Side handles are positioned at an angle forward for added comfort.
- Small diameter grip (only 2-1/4")
- Suitable for welders, assemblers, bricklayers, maintenance/repair, etc.

     1 set contains

1 x MAKITA GA4030 Grinder
1 x 4" x 3/16" x 5/8" Grinding Wheel, 24 Grit (741402-B)
1 x Inner flange (224377-1)
1 x Lock Nut (194608-1)
1 x Inner flange (224377-1)
1 x Nut Wrench (782420-7)
1 x Side handle (153504-2)

      Purpose of use of the MAKITA grinder model GA4030

This tool is intended for grinding, deburring, cutting metal and construction stone. without water

      Power supply of the MAKITA grinder model GA4030

The tool must be connected to a power supply with the voltage specified on the machine information label. and must use only one phase AC power This appliance is double insulated as stipulated in the EU standard. and can be used to plug into an ungrounded electrical outlet

       Working of the MAKITA grinder model GA4030

- No tool pressure is required. The weight of the machine already has enough pressure. Forcing and applying too much pressure can damage the chia blade.
- Change the chia leaves every time. If the tool falls to the ground while grinding
- Do not hit or hit the disc or grinding wheel while working.
- Avoid bouncing or hooking of the blade, especially when working with corners. Sharp edges, etc., as such events can cause loss of control and bounce.
- Do not use this tool with hacksaw blades and other saw blades. Because if the saw blade is used with a grinder, it tends to bounce back often. and cause loss of control which can result in injury.

      Precautions of the MAKITA grinder model GA4030

- Do not switch on the tool when the machine is in contact with the workpiece as this may cause injury to the operator.
- Wear goggles to prevent dust/wind. or face mask every time while working
- After the work is done Always switch off the tool. and wait until the grinding wheel stops spinning completely before putting the tool down.

     Care and maintenance of the MAKITA grinder model GA4030

- Before checking or maintaining the machine Always make sure to turn off the power and unplug the machine.