Cordless Hammer Driver Dril MAKITA DHP453SF1J

      Cordless Hammer Driver Dril MAKITA DHP453SF1J power 18V.

Size 1/2'' (13 mm.) H/S:42/27 N.m Variable speed trigger included 74 piece drill

        Intended use Cordless Hammer Driver Dril MAKITA DHP453SF1J 

               The tool is intended for impact drilling in brick, concrete and stone as well as for drilling without impact in wood, metal, ceramic and plastic. 

        Speed change Cordless Hammer Driver Dril MAKITA DHP453SF1J 

               To change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or "1" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. 

        Adjusting the fastening torque Cordless Hammer Driver Dril MAKITA DHP453SF1J 

                The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow.
                 Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. 

             Hammer drilling operation Cordless Hammer Driver Dril MAKITA DHP453SF1J 

                       First, turn the action mode changing ring so that the arrow on the tool body points to the marking. The adjusting ring can be aligned in any torque levels for this operation.
                       Be sure to use a tungsten-carbide tipped bit.
                       Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. Light pressure gives best results. Keep the tool in position and prevent it from slipping away from the hole.
Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. 

              MAINTENANCE Cordless Hammer Driver Dril MAKITA DHP453SF1J 

                       Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.
                       Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.