HAMMER DRILL MAKITA M8103B

    HAMMER DRILL MAKITA M8103B

size 13mm.(1/2") power 430 W

Capacity Concrete:13 mm, Steel:13 mm, Wood: 18 mm

     MAKTEC MAKITA M8103B

            Use for drill wood, metal, stone, concrete and plastic.

     Power source for MAKITA M8103B

            Must be use with Voltage 240 volts, and Use with Single-phase electric power. 

            This product is cover by Double Insulation, Can use with no grounding power system.

      Instruction for install or remove drill bit MAKITA M8103B

             1.Open the chuck jaws, and insert the bit intothe chuck.

             2.Place the chuck wrench in each of the three holes in the chuck, and turn it in the clockwise direction. Tighten securely

             3.To remove  the bit, place the chuck wrench in one of the holes in the chuck and turn it in the

                counterclockwise direction

     OPERATION MAKITA M8103B

          CAUTION:

           Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations.

    MAINTENANCE MAKITA M8103B

        - Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.

        - Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.

     OPERATION MAKITA M8103B

        When drilling in concrete, granite, tile, etc., slide the action mode change lever to the position of g symbol to use "rotation with hammering" action. Be sure to use a tungsten-carbide tipped bit. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out. After drilling the hole, use the blow-out bulb to clean the dust out of the hole

     STANDARD EQUIPMENT