Cordless HAMMER DRILL Dewalt DCD996N-KR 18V. (Body only)

       Cordless HAMMER DRILL Dewalt DCD996N-KR 18V. (Body only)

interesting features

- Extended Runtime - High efficiency with brushless motor Compatible with 5Ah high capacity battery packs.
- More power - 820 UWO allows more versatility.
- Operation speed is 43% faster with percussion hammer increased to 38,250 BPM.
- Faster clutch control via E-Clutch (Electric Clutch)
- Improved tool life - Coated and sealed switches Excellent moisture and dust resistance
- Improved airflow Allows the motor to run at lower operating temperatures.
- Unique LED light, adjustable 3 levels, increase the brightness of the work area. It works smoother than before.
- The handle is designed according to the shape of the hand. work without fatigue

Applications - This tool is used for hammer drilling in brick, concrete and stone and can also be used for screwdriving and drilling in wood, steel, ceramics and plastics. without using shock as well

Switch operation

- To activate the tool pull the switch to operate The tool speed increases when the actuation switch is applied. Release the trigger switch to stop working.

Installing and removing screwdrivers or drill bits

- Turn the sleeve counterclockwise to open the chuck mouth. Insert a screwdriver or drill bit into the chuck as far as it will go.
- Turn the sleeve clockwise to tighten the chuck. to remove a screwdriver or drill bit turn the casing counterclockwise.

Drilling of the drill

- First, turn the adjusting ring until the arrow points to the mark. Drill bit, then do the following steps.
Wood Drilling - To get good results when drilling wood. A wood drill should be used in conjunction with a lead screw. The lead screw makes drilling easier by pulling the drill bit into the workpiece.
Drilling in metal - to protect the drill bit from sliding when starting to drill. Make the cuts with a center drill bit and a hammer. at the point of penetration Place the tip of the drill bit at the cut and start drilling.Use cutting lubricant when drilling metal. except for drilling steel and brass which should be drilled dry
- Always apply pressure to the drill bit. Apply enough pressure to allow the drill bit to drill. Don't push too hard will cause the motor to stand still or the drill bit warped
- If the drill gets stuck, usually due to overload, release the trigger immediately, remove the drill from work. and find the cause of the interruption Don't just push the tool on and off to try to start a jammed drill. as this may damage the drill.

Screw operation

- Select the desired speed/torque, however. For optimal screwdriving performance, 2 and 3 speeds are recommended.
- Set the torque adjustment sleeve This is the appropriate numerical setting for the required torque. Do a few rounds of testing first on scrap or invisible areas. to determine the proper position of the torque adjusting sleeve.

Impact drill operation

- Select the desired speed/torque range using the gear lever to match the speed and torque to the planned operation. Set the torque adjustment sleeve to the hammer symbol.
- When drilling, use enough force to impact. so as not to bounce too much Prolonged and excessive use of impact mode will slow down drilling speed and possibly overheating.
- Apply force to drill straight parallel to the angle of drill. Do not exert lateral pressure on the drill when drilling as this will clog the drill groove and slow down the drilling speed.
- While digging deeper Then the drill speed decreases, pulling the drill partially out of the hole with the tool still working. Helps to remove debris from the holes
- For drilling in masonry, masonry, use a carbide-tipped drill or a masonry drill bit for a smoother and more consistent force.

1 set contains

1 x Dewalt DCD996 N-KR
1 x Side handle
1 x Manual and Warranty Card
1 x packed in a paper box
**This product does not include battery and charger**