Cordless Hammer Driver Dril MAKITA DHP453Z (SOLO)

Makita DHP 453Z LXT 18 Volt Lithium ion Combi Drill (Naked), featuring 2 mechanical gears, electronic brake control, forward/reverse rotation and variable speed trigger.

Features:

2 Mechanical gears

Electronic brake control

Forward/reverse

Variable speed trigger

Double end Ph Bit

No batteries, charger or carrying case.

Product Specification

Max in Steel: 13mm

Max. in Wood: 36mm

Max in Masonry: 13

Torque Settings S/H Nm: 16+ drill

Max Torque: 27/42Nm

Blows per minute: H:0-19,5000ipm L:0-6,000bpm

No Load Speed: H:0-1,300rpm L:0-400rpm

Net Weight: 1.9kgs

Total Shipping Weight: 3kg

      Cordless Hammer Driver Dril MAKITA DHP453Z power 18V.

Size 1/2'' (13 mm.) H/S:42/27 N.m Variable speed trigger included 74 piece drill and drive set 

        Intended use Cordless Hammer Driver Dril MAKITA DHP453Z

               The tool is intended for impact drilling in brick, concrete and stone as well as for drilling without impact in wood, metal, ceramic and plastic. 

        Speed change Cordless Hammer Driver Dril MAKITA DHP453Z

               To change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or "1" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. 

        Adjusting the fastening torque Cordless Hammer Driver Dril MAKITA DHP453Z

                The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow.

                 Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. 

             Hammer drilling operation Cordless Hammer Driver Dril MAKITA DHP453Z

                       First, turn the action mode changing ring so that the arrow on the tool body points to the marking. The adjusting ring can be aligned in any torque levels for this operation.

                       Be sure to use a tungsten-carbide tipped bit.
                       Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. Light pressure gives best results. Keep the tool in position and prevent it from slipping away from the hole.
Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. 

              MAINTENANCE Cordless Hammer Driver Dril MAKITA DHP453Z

                       Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.

                       Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.